Mounting A Screen Door Closer

This step by step instructional guide shows an ideal security closer but the steps a.

Mounting a screen door closer.

Align the closer with the screen door so that the end is touching the door. Step 2 to position door bracket on door attach it to body of closer place rod of closer in jamb bracket and with door closed hold it against door. Adjust the length of the chain. Hold the door bracket up to the end of the closer and make a pencil mark where it is to be located.

Storm door closer installation how to install a storm door closer drill 1 8 inch pilot holes for the screws. Door closers with a regular arm will be mounted on the pull side of the opening. Make adjustments to your pneumatic screen door closer storm door closer twice a year when you exchange the screens and glass storm panels. To install a hydraulic door closer fasten the door mounting bracket to the door s top rail.

Slide the washer past the lugs lining it up with the mark on the rod. If it s too long the door will keep slamming shut. Instructions for installing or replacing storm and screen door closers. Pull open the door closer a bit.

For you to note check product specifications for correct positioning. Step 1 place jamb bracket of door closer on hinge side at top of door jamb. Screw bracket to door jamb. Place the hold open washer onto the rod that extends from the door closer cylinder.

Connect the door closer rod. Measure from the screen up onto the frame 5 8 inch in the same location as the end of the closer. To accomplish this door closers are filled with hydraulic fluid in a pair of sealed chambers separated by adjustable valves. The closer body will require the top rail of the door to be wide enough for installation otherwise a mounting plate will be needed for proper installation.

Move the long connecting pin into the forward hole for winter or rear hole for springtime of the closer each time you change the storms or screens. If it s too short you won t be able to go in and out easily. To do this it has to contain a spring but the action of the spring must be modulated to prevent the door from slamming. The closer body is mounted to the top of the door and the closer arm is attached to the face of the frame head.

A properly tuned screen door closer pulls a door closed gently but firmly in about eight seconds. Mount the jamb bracket to the head jamb. If your screen door does not shut on it s own it may be time for a new door closer. Installing a hydraulic door closer.

Place the bracket against the door jamb again and screw it to the hinge jamb using the supplied screws and a philips screwdriver.