Msd Shift Light Install

Connect the green wire from the msd shift light to the purple orange wire in the third slot of the switch.

Msd shift light install.

When disconnecting the battery always remove the negative cable first and install it last. Tach signal is a white wire on 32 pin red connector pin 13 if installing the raptor dual mode shift light connect the white wire of the shift light to the vehicle speed sensor vss output signal from the 32 pin pcm black connector pin 8 da. Whenever the ignition is turned on the shift light will illuminate for a couple seconds to indicate that it is operational. 1 shift light 1 mounting bracket 1 gmr pickup pn 8918 2 washers 1 brass screw 1 parts bag up mode down programming buttons red to.

Msd s new compact digital shift light can be installed on all types of motorcycle and atv applications. This is a ground wire. The shift light installs easily with the gmr pickup or through the tach output terminal of an msd ignition control or aftermarket ecu. This msd shift light features two switches that allow the driver to control the leds intensity.

The most universal and easy to use shift light available. During installation disconnect the battery cables. The most universal and easy to use shift light available. Connect the black wire from the shift light to the black wire in the number four slot of the switch.

Our new compact digital shift light can be installed on every thing from 1 cylinder points triggered engines to modular ford engines with coil on plug technology the tiny digital controller inside the compact housing gives you the ability to program the rpm activation points through the easy to view led panel and two programming. Msd digital shift light pn 8963 warning. Never connect the green wire directly tithe coil negative terminal. If it does not light check all of the wiring connections and for voltage on.

Powertv installs a dsl digital shift light in their project 666 fox body mustang. Msd digital shift light with adjustable intensity. Accurate and repeatable shifting means you ll be going down the track faster and more consistently. Connect it to the tach output terminal of an msd ignition control.

With msd s programmable shift light you won t have to wo. When installing the shift light disconnect the battery cables. It will accept a trigger signal rated from 0 24 volt amplitude. On factory inductive ignitions without an msd connect to the coil negative terminal.

When disconnecting always remove the negative cable first and install it last.